I'm beginning to clear out some parts I bought and never used. This is one of Rob Giroux's beautiful billet thermostat housings. Never installed,...
[ATTACH] hi guys. Long time since I’ve been here. Sadly I’ve been moving and have to clean out. I have a small block Buick I was saving for...
After 3 years of scheming and planning, Isaak and I are about to finally embark on the engine build for our '72 Skylark. Placed the second...
Was wondering if any of you have done this or if it is even possible to do with the technology that is available ie. No aluminum heads.
Looking for cheap set of 350 buick headers
Hi all. I’m new to the board, but not so new to my '72 GS 350 (bought it in '94). It’s basically stock except for a 2-1/2 manifold-back exhaust...
Im looking for a clutch setup for my gs 350 and want to do it on a budget. The motor is basically stock and shouldnt require any kind of...
Looking for sbb flywheel, no problem if it needs turned.
Hi All, Craigslist. Good and bad. Good: SBB TA-284-88H cam, TA 1436 dual springs, TA 1405 lifters, TA 1523 Double Roller timing chain set -...
I might pick up a Buick 350 out of a 1973 Apollo. The price is right. However, I cannot find good information on what flywheel I will need for it....
from a v6 231 to a 72 buick 350 ive swapped all my acc over but the water pump pulley from the 231 for some reason isnt lining up to the waterpump...
got a 1972 buick 350 from a skylark going into my 83 regal my mech cant find a manual on the 72 skylark hes trying to figure out where to set the...
how many ppl have swapped the 231 with a sbb 350? for some reason the frame mounts on my 83 regal fit the buick 350 out of the 72 skylark but isnt...