<<<<< Finish Line builds me a 756 hp power plant >>>>>

A big :TU: to Bobb & Geoff @ Finish Line Motorsports. I have just taken delivery of a 482 cid power plant that made a conservitive 756 hp @ 6500 RPM & 666 ft/lbs @ 5500 rpm which I hope to get my Somerset into the 8's
Brief details are:

482 cid
14.5:1
Stage 1 TE HEADS
Aluminum rods By Precision Billet
1050 dominator
Custom flat tappet cam
Stock crank heavily modified
super light pistons
low tension ring package

 

Those are the coolest valve covers I have ever seen. Is this the one dynoed last week?

 

Very nice love the valve covers.Nothing says not a chevy like a big in your face BUICK

 

yes it is. On the dyno last Thursday, delivered to my house Saturday morning, in the car running Sunday.

 

Are you coming to the BPG in two weeks? Can't wait to see your car run with the new mill.

 

I will be there. Have you had the new car out?

 

can i be the 3rd person to say awesome valve covers.:TU:
Sounds like it'll be an awesome engine as well.

 

Hey Rob,

NICE engine!! Did they stop the dyno pull at 6600 rpms? Did the HP begin to go down?

See you in Columbus!!!

 

WOW!!!!! on the valve covers. How much would a pair of those be???

 

They stopped at 6500. The power was still climbing but the oil was hot because they were on the 7th pull. Also the air temp was 90 degree with high humidity. The power could be closer to 780 @ 7200.

---------- Post added at 06:08 PM ---------- Previous post was at 06:02 PM ----------

How much you got:dollar::dollar:

 

Rob, The new car is at the chassis shop being upgraded to 25.1E specs. We also are moving some stuff around so I can be comfortable in the car. With the way the progress has gone so far I'd say we should be ready for shake downs 1st of September.

 

Looking good Rob! Can't wait to see it run...very soon!

 

Very cool! Bobb is the MAN!

 

That is one awesome piece!!! Ill be looking for it at bpg for sure!!

 

Im really diggin the valve covers whats a pair of those cost??

Thanks

 

Looking good Rob. Can't wait to get get my hands on it friday nite. Just in time for the chassis class!

 

That's one mean looking bullet,good luck with it.:3gears:

 

Looks Awesome! Are you building a TA Alum. 600" motor for the new car? We are working on 500 CFM heads for them (very close now, hope to see them Thursday) and beyond from billet heads. Keep up the great work and give my Kudos to Bobb, great guy!

 

George,
I honestly couldn't say what the valve covers cost. I didn't have a need to keep track of the time it took to make them.
I can say that those are machined from a solid block of material.

 

wow!!id love to have a set of those,looking good Rob!