Parting 1971 Skylark

Roof is good. I want to remove the back glass to see just how nice the rear tray is.
The body has a repop 1/4 on the driver’s side that the previous owner installed. It still needs the excess lip flange in the wheel well removed. I don’t mind cutting into that one,BUT,after looking this body over,I found that sometime m the past,an NOS 1/4 was installed on the passenger side,and is still near perfect,so I would like to keep that as a full 1/4. The problem is then you sacrifice some of the roof and the trunk,depending on where you cut in the trunk.All of it is real good,but I won’t sacrifice a full 1/4 for the surrounding parts.
The only real bad spots on the whole body are in the front lower corners of the cowl,where the fenders bolt on. They are both a little cobbled. The passenger front pan had a section welded in,but was done fairly well. I
I may try and sell the body shell whole.

 

The clutch fan is 18”.

 

Is the piece circled below complete and is the plastic "chalky?"

 

Ok, let me take a look and see if the fan is correct for a '70.

 

Geez. What a job on the lower cowl.. keep me posted on the roof. I'd be looking for the upper skin only...

 

Peak reveal moldings sold

 

If I can separate the roof from the passenger 1/4 correctly,we would be good. I can cut excess for the other corners. I need to dig into it and see how they did it. They did go all the way up,I can see that much. This car also has a previous NOS RH fender,and the inside of the RH door has a different paint,so I think the whole side was repaired at one time.

 

I am casually shopping. If you would rather slice the roof to save the 1/4s I would understand and my feelings wouldn't be hurt one iota.

 

I’m hoping I can separate them correctly at the natural seam.

 

Very nice AC dash pad. Still soft and NO sag over the gauges. Nothing broken or missing.

 

Brian Do you have a front Bumper from the Car .

 

Brian... PM Sent

 

Jim,
I have a pair of 71 bumpers,but I had a person interested before I even listed the parts,so I did not mention them. If I can get them to him,he will take them. If the deal falls through,I will let you know.

 

Ok Thanks Brian

 

In-line LH fender....PM

 

Brian,
let me know on dash pad.
Nelson

 

How much for dash pad ? pics rh fender?

 

The dash pad is $250.00 There is one person ahead of Redmanf1,then GSXER.
I will put GSXER tentatively inline for the RH fender,should I decide to sell it. I literally bought two RH fenders last week because I didn’t have any to my liking. Now I have 3. Two used and one NOS. I need to get the other two here,lay them out,and pick which ones I want.

 

Interested in pair of headlight bezels. Pics aren’t clear so if you still have them when I drop fender off, I can just pick up when Im There

 

Jim,
The 71 bumpers are sold and paid for.