Parting 1971 Skylark

Parting out a 1971 Skylark project car with a lot of good parts. Just taking pictures and looking them over as I go.
Grille - nothing broke or chipped,bottom center stud has stress crack,but not loose or weak. $125.00 SOLD
Charcoal canister with bracket,$25.00
Front wheel well moldings - no dents or damage,or extra drilled holes,$100.00/pr.
Rocker stainless moldings - no dents or damage,$100.00/pr. SOLD
Peak reveal moldings,$100.00/pr. SOLD
Rear seats - very nice originals,still soft,the upper top only has one small split and a scuff,$200.00/pr.
Front bench with center arm rest,$100.00
Clutch fan,$30.00
Fan shroud - both mounting ears have a crack,but nothing broke or missing,$50.00
Trunk lid - no rust or damage,drilled for the optional stainless moldings,$100.00
1/4 panel end caps with chrome trim,$50.00/pr.
Headlight bezels,$80.00/pr.
New stainless gas tank,installed but never had fuel in it,$250.00
Front door arm rests - the bases are still presentable but a little dry,upper pads are good,$30.00/pr.
Driver’s fender -repaired at the bottom,$75.00
One-piece driveshaft with TH350 yoke,55” joint to joint,$100.00
I will add more parts as I get pictures and list them.

 

Interested in rocker and fender well mouldings

 

Rear seats

 

I'll jump in on the gas tank & rocker moldings (hardware?).

Does the bench seat have the plastic piece behind the armrest?

What's the fan diameter (I thought '71 was 5-blade)?

 

Fan and shroud

 

Front wheel well moldings,rocker moldings,driver’s side fender,1/4 end caps,peak reveal moldings

 

Front seat,gas tank,trunk lid

 

Headlight bezels and front door arm rests

 

Here’s some more parts not listed above.
LH fenderwell - nice,but not perfect,has a ripped hole and a goober weld patch at the front tip. $80.00
Original 71 alternator with 2-groove pulley,$75.00 SOLD

 

In line for peak reveal moldings. PM on it's way.

 

Front grille support and latch assembly,$75.00
Vinyl top trim stainless - one piece is slightly distorted from the fastener,but can be repaired,$25.00
Door jamb windlace - no splits are cracks on either one,$30.00/pr
Roof rail side windlace,$25.00/pr
I do NOT have the front or rear glass windlace.

 

This is what I have of the seat belts. I wish I had all of them because they look like they were all nice deluxe belts Front retractors are nice. The covers are not discolored or chalky,but each one has a crack. Two other male belts is all I could find.
$35.00 for what is shown. SOLD

 

Inline seat belts, rear armrest and alternator

 

So far away ugh. I'm sure shipping would be crazy on the drivers fender.

 

Where are you? I have two LH fenders that both have repairs like that.

 

Dano,
The piece behind the arm rest is plastic.

 

Ok - Let me check something.

 

How is the roof, Brian?

 

Brian:

I'm interested in the clutch fan, DS Fender, and front grille support/latch assembly

 

Haslet, Tx