Looking for some feedback. >>Preferences for plug wires? Pro Sidewinder, 8mm, 10mm, custom make, prefab, preferred vendor??? >>How about plug type and Gap? Block is O-ringed. Reliefs cut in Pistons. 430 Heads that are heavily ported, polished, intake matched. 600-ish HP combo. 12:1 compression. MSD 6AL. This is my first complete race car project (my excuse for remedial questions) Any input appreciated. Thanks! John
Hi John, Ive used tailor 409 wires 11mm..The wires i think are great and never had a problem with them... just my input Plugs ?? my opinion go with a cold A/C delco like a 42TS ..sounds like a great combo you have Lots of HP :Brow:
I've run sidwinders (MSD 8.5) and Taylor Wires (spiral 8.0). For the money, I'd go the Taylor route again. Their about 20.00 cheaper, and I couldn't tell the diff in performance. as for the plugs I run a cold NGK
I've always been partial to Taylor wires. MSD wires are good too. They both have the lowest resistance out there. I still like NGK V-Power plugs.