Hi i need to replace the floor of my trunk i only need the flat part ,who makes the best fitting replacement. thanks todd
Hi Todd, I used the 2 peice from OPGI, I think NPD has the same one. TimR used one as well and the fit was excellent. He has an evauluation on his web site http://members.shaw.ca/timcr/trunkfloor.html If you only need the center part I have a 1 piece I did not use. It's brand new. There are a few ribs that may need work to get them to line up. PM me if you are interested in it. You're close enough to take a look and see if it would work. I'd like $75 for it.
floor hey the floor in my car is mint but they cut it to put in fuel cell i would be interested in it if it covers the center of mine thanks mark 716 523 1764
If you want to see their trunk floor installed, I have pictures now of before and after the NPD trunk floor went in... Later Tim
And after..... If you want to see the installation, go to my webpage, click on the convertible picture, then follow the body link, it shows a couple pictures of the install. Overall I am very happy with how it turned out. I still needs speckla paint of course, but that will have to wait until the body is painted... later Tim
wow it looks great , what a difference that floor looks original the piece i am missing is were the fuel cell was cut out the trunk looks just like your with a hole cut out
The goodmark panel didn't seem to be shaped correctly at the outboard ends, and it was thinner metal, but yeah if you only need the center section that might be the way to go. later Tim
What is considered the center section? Is it the part that the drain plugs are in? The falt center part that the gas tank is up against and is basically the whole floor?
Here is a picture right off goodmarks site...this is the three piece floor. they also make a one peice floor that doesn' go right to the edges. AND if looks like they have revised the ends, they used to be incorrect before, now they stop where they are supposed to. Go figure. goto goodmarkindustries.com and they have pics and info. Later Tim
thanks tim will do, figures i would need the complete piece because it goes into both sides past the middle just enough were the fuel cell sat.