Need help removing alxes out of a 12 bolt

Discussion in 'Race car chassis tech' started by 462 GILLEY, Mar 31, 2005.

  1. 462 GILLEY

    462 GILLEY Well-Known Member

    I got a new set of Centerline wheels and have decided to install new 1/2 inch studs.
    What is the procedure to removing the axle out of the rear end?

    Thanks
    Mike
     
    462 GILLEY, Mar 31, 2005
    #1
  2. Shayne Dillinge

    Shayne Dillinge Well-Known Member

    It's pretty easy.

    - remove wheels and brake drum
    - remove rearend cover and drain fluid
    - remove the bolt that holds the spider gear pin in place
    - remove the spider gear pin
    - push the axle straight in towards the center, should move about .375"
    - remove the C-clip, a magnet can help
    - pull the axle out

    I think that's it. Can anyone think of anything I'm forgeting? :Do No:

    Good luck.
     
    Shayne Dillinge, Mar 31, 2005
    #2
  3. 462 GILLEY

    462 GILLEY Well-Known Member

    Thanks Shayne.

    Mike Gilbert
     
    462 GILLEY, Mar 31, 2005
    #3

Share This Page