I installed an Edelbrock 750cfm on my brothers 1970 Skylark a while ago. I am a bit conerned about the rubber fuel line that I had to substiture between the pump and the carb. The stock line no longer works because the service entrance for the fuel is at a 90* angle on the pass. side of the carb. What is the best stuff to use (braided steel line?) and what is the best way to route it? Thanks, Ken
the way i did it on mine when i put an ebelbrock on was i bent a length of steel linethat runs up fromthe pump and along the inside of the left bank rocker cover then used some rubber line from there to the carb i also had an inline fuel filter in the rubber line. it worked very well