I am considering building a turbo 350 motor and wanted to see if there was any interest in this. Finishline built the motor for me a couple of years ago and it has less than 20 passes and about 400 street miles. It has JE pistons, TA Rods, girdled block, deep pan with scavanger oil system, sp2 intake, stg2 track eliminators. I will be offering this motor complete minus carb, water pump, and msd. Attached is a photo of the engine and dyno sheet. I had issues with my carb on the dyno and didnt have the air bleeds to further tune so there was power left on the table. The dyno was done on 93 octane and there are no issues with this engine at all. Over 15k+ invested I'll sell it for 10k
I believe it is 11.2 to 1. Keep in mind there is a street strip cam in this motor its not max effort. This was built to run on the street and then run in the 9's at the track.
Herb, What car was the motor in and what was the ET/MPH? Why the switch to the turbocharged small block? Thanks.
It is in a 72 stage 1 right now that is too nice to race in my opinion. It has been 9.90s high 130's with 3.73 and 30" tires. It would pick up with more gear. I have 7 455s time to do something different.
Herb, The timings not right for me. I'd love to put this in my sick little Nova idea that I have but April 15th will be here soon. I'll get out of the way.
Herb, I better get in line so we can discuss what you have. It might be too much motor for my project...well, it is. I'll be in touch, thanks for your message. Machinefarmer