Ok guys i took the v6 out of my 85 regal ready to put in my 69 350 4 my question to u is since i am not gonna connect my smog pump how do i go about connecting the hoses and all it was a rochester carb on the v6 and i am switching to the edelbrock a very big difference with connection section anybody that wants to give info please feel free.
You'll have to cap the line off the Catalytic converter. There are three (or four?) lines off the charcoal canister that will need attended to. One is a tank vent. Being that your in LA, you might wanna figure out something different than just venting into the atmosphere.
if yor putting in the 350 with the edelbrock carb you probably wont be avle to connect all tha suff only thing you should have to worry about is hooking up the pcv the vacuum for the vents in the car trans vacum and distributor vacuum. most of the rest you could probably delete. As far as the canister you could remove it but if you have strickd pollution laws you need to check about doing a swap as you may not ba able to enjoy the vehicle after all your work!
if the carb is emmisions legal it will have a evap port on it for the canister check with the directions or edelbrock tech line. you might have to change canister to 2 port or remove the vacuum valve and run straight to carb i have hooked them up before but i used the q-jet type carb
i'll keep the canister its just that this is my first drop and i just wanna complete and after i complete then i'll worry about the other stuff later.
