Domintor spacer plate

Discussion in 'Parts wanted' started by DMoore, Apr 2, 2005.

  1. DMoore

    DMoore Well-Known Member

    I know a few of you are running these, but i cant find them anywhere on summit or jeg's websites. What i need is the spacer that goes under the carb and is the plate that you can bolt the fuel pressure regulator to, i need this for a dominator though. If you know the part number from summit or jegs, that would do to.

    Thanks in advance
     
    DMoore, Apr 2, 2005
    #1
  2. Tom Rix

    Tom Rix Well-Known Member

    Part Numbers

    Denny,

    Depending on what type of regulator you use the Jeg's part #'s are 555-15290 through 555-15293. Cost is $24.99. Good luck.

    Tom
     
    Tom Rix, Apr 2, 2005
    #2
  3. DMoore

    DMoore Well-Known Member

    Close

    Tom

    Those ones look as if they will work, but not exactly what i was thinking. The regulator is a holley one, and the plate that i have on Renee's car is a complete plate.

    I am going to check into these anyway. Thanks again Tom.
     
    DMoore, Apr 2, 2005
    #3
  4. GS Kubisch

    GS Kubisch THE "CUT-UP" BUICK

    Denny
    It's better that the regulator not be mounted solid,On a Pro Stock for instance,They are just supported by the fuel lines.

    I have an aluminum plate that bolts under a Dominator you can check out if you want.
    I used until I took off the Paxton regulator to upgrade the the Magnafuel.
     
    GS Kubisch, Apr 2, 2005
    #4
  5. DMoore

    DMoore Well-Known Member

    Thanks Guys

    Gary

    I ended up finding the plate through Summit and it is made by Edlebrock.

    My question for you would be, what are the benifits of having it not mounted solid? I understand what you are saying about having it supported by the fuel lines, but i dont get the benifits and always thought that it had to be mounted for it to be legal.

    Thanks
     
    DMoore, Apr 3, 2005
    #5

Share This Page