I don't know how much differently that fork could be welded, it would have to be offset at the end and the stock ones I've seen pics of look like mine for the most part. I put a double heim joint in there and the problem was solved, like the bushing in the rod is too stiff, or the bushing itself should be offset in the rod, but without the tension of the rubber bushing the fork sits properly, but is my geometry right? I don't know. Still waiting for word from Dave. Well, he has me adjust the pedal to have 1/2 inch travel so I do, and because the link to the z bar causes the fork to tilt, a 1/2 inch of travel at the pedal means the throwout bearing is in constant contact with the clutch fingers, Needless to say I will not run it this way, and will use the heim joints and hope that does it.
