Cadallic Starter

Discussion in 'The Bench' started by IDOXLR8, Nov 8, 2003.

  1. IDOXLR8

    IDOXLR8 Senior Member

    Guess where the starter is on a 1997 Cadallic STS with the Northstar 32 valve engine. I will give you a hint, you will not need a floor jack and will not see it untill you remove the intake manifold. Incredable, but not a bad job and looked more diffacult then it really was. I know this is not Buick related but some of you may find interesting. AL
     
    IDOXLR8, Nov 8, 2003
    #1
  2. Floydsbuick

    Floydsbuick Well-Known Member

    I know exactly were it is. Under the intake manifold at the rear of the engine!
     
    Floydsbuick, Nov 8, 2003
    #2
  3. Mark Dalquist

    Mark Dalquist Well-Known Member

    Gravy money my friend, gravy money. You don't even have to raise the car. Job pays around 2 hrs if I remember right, It really only takes 45 min to an hour if you're good though.:Brow:
     
    Mark Dalquist, Nov 8, 2003
    #3

Share This Page