buick 350 lunati voodoo camshafts

I'm pretty pleased with my TA 212 cam since it made 398 hp and 425 tq without any boost. With the forged pistons, late model rods with arp bolts ect it is read for boost!

 

can i see the torque curve on you dyno sheet sean
i want to make a low rpm very hi torque 350 before boost
if i can get it to feel like driving a 'minibigblock'
i would like to see 300 lbs by 2500 and over 400 around 3000

 

Mine made 425 f/tq at 3800 and was above 300 from the 2000 rpm pull.

 

maybe my goals should be higher

 

Keep the lobe centers close and the duration in the 220 range.

 

so one of these is what i am looking at
219/227 @ 050 and 112/108 lc
or 227/233 @ 050 and 110/106 lc

 

Go with the 227/233 cam, It will be a KILLER!

 

http://www.v8buick.com/showthread.php?t=140470

http://www.v8buick.com/showthread.php?t=140060

 

What is the lift??

 

Lunati says lift for #67003 is .505/.521 @ 1.55 ratio. With 1.6 ratio, mine should be @ .522/.537.:laugh: Click on cam card & click on it again to sharpen image. Sean; your're good at finding those old threads .!!!!:laugh:

Marty

 

i pm'ed mike atwood hoping you could run these cams thru his desktop dyno
get some estamites.
but it seems he aint been on in a while

 

STuff that in and run it! Just re-check you guide to seal clearance with the lift.

 

LOL, its my job!

 

LOL, its my job!

Sean; you're doing it well, theres not a post that gets by you, my friend!! heck, you're like a WORKING moderator!!:laugh:

 

I try my best, and I do get paid for it, just not by the V8 board....

 

Harold Brookshire designed those lines of cams. He posts regularly on chevelles.com and speedtalk.com . He knows what he is doing. I think you will be happy with that cam.