can someone tell me a good place to get a good rebuild kit for borg warner t10. im going to do it myself so i need all the parts. Thanks
I did one myself. I also made a little mistake. When you take it apart be sure to use a micrometer to measure the little snap rings, put them in baggies and mark where they go. I couldn't tell the minute difference in their thickness and put the wrong one in the wrong place, which means two were reversed, the thick one was where the thin one went. Everything felt fine until I finished buttoning it all up, then it wouldn't turn! I had to tear it apart again and fix my mistake.ou: :error: I only did the one T-10. A few muncies, but either the snap rings in the Muncies are the same or I was lucky as I had no problem with them.:TU: Also the T-10 raked going into second gear after I got it back in the 65 GS convertible I was working on. I knew it was the brass ring not working as it should, but didn't want to buy a bunch of extra parts to find one that would work better, so I took it to Dennis Maroudas, who is fairly close to me, and had him work on it. He said he tried every piece of brass he had and used the one that he thought worked best. He thought the gear may have wear and kept the brass from doing a great job as it should. It worked OK when he got it finished. You might call and get your parts from him, several people on the board have used his services and I have not heard anything negative. The number I have is 606-237-6648. I knew him before I found this board so the number is from several years back. Good luck, Mike
Portland Transmission guy are very nice. all the parts you need in stock and cheap. thank Paul for the info.
