Todd has the factory diagram which is awesome. I have a set of slmost new bushings that I think have been kicking around a while but still really good. But I don't know if I have enough of the right ones... I do have the bottom part of the bushing) The flat rubber ones on the left. I know I need 4 and those go into mount holes 4 and 5 in Todd's pic. Bushings with part #8380. I actually have 10 of these. Would these all go into mount locations 1, 2, 3, 6 and 7? (Do all these mount holes use the same bushing?) The 2 bushing with part# 2734 immediately to three right of 8380 are the same height as the 8380 bushings but smaller. The 3 smaller ones on the far right do not have part #, they are smaller than 8380, same diameter as 2734 but touch a couple millimeters shorter. Appreciate any guidance as to where they all go. Thanks! The