72 Buick 350 throttle cable linkage???

Discussion in 'Small Block Tech' started by lildavecurtis, Nov 17, 2020.

  1. lildavecurtis

    lildavecurtis Davendalark

    Did you have to make any adjustments for it to work?
  2. lildavecurtis

    lildavecurtis Davendalark

  3. alec296

    alec296 i need another buick

    No adjustments needed
  4. lildavecurtis

    lildavecurtis Davendalark

    Got the new bracket installed on fabbed up bracket base i made. So i could get extra slack out of throttle. It opens secondaries almost to WOT. But now pedal doesnt touch floor about 1 inch or so off floor fully depressed. Throttle does close fully when let go of pedal tho. So im guessing gonna have to get TA throttle cable that was mentioned up above. Unless someone has anymore ideas.
  5. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD" Staff Member

  6. lildavecurtis

    lildavecurtis Davendalark

  7. Mart

    Mart Gold level member

    I would try a different mounting hole on carb bell crank. Shorten the travel up needed to open blades fully....
  8. Dano

    Dano Platinum Level Contributor

    Fwiw, the 350-4 cables are the same for '68-71 but '72 is a different part #. I don't know they physical differences but...

Share This Page