The chrome is ok for a daily driver, I replaced it because it look like one side didn’t have the rounded corner, maybe pulled out $50 pick up only Columbia SC
Ricardo, It looks to me like the area that wraps around the fender is curved a bit. It should be strait, after it makes the turn at the peak. The way it appears it will likely touch the fender. Probably straiten out relatively easy. Have someone help hold it up on end, place it on a block of wood and take a heavy dead blow hammer and roll it around flat/strait. It may or may not pop the chrome. I'm betting if it original chrome, it will be fine thou.
If you zoom in on the second picture you can see the spots where the chrome is thin. There’s spots like that in numerous places. The bumper is at my job I’ll be there on Friday.
LoLo as mentioned the corner of the bumper may have been pulled out/in and the corner pictured shows it's not contoured like from the factory. It was close to the fender when I had it on my care, however, it wasn't touching. I didn't get any alerts for posts to this thread until this morning .