I have a 65 skylark and purchased hood scoops from a 67 gs. Is the hood on the 67 gs molded to fit these scoops or can these scoops be bolted directly to the 65 without molding it with fiberglass? o No:
They should just bolt on You need to drill the holes and should be ok. When its done you should post a pic. I may do it to my 64 hood. Thanks
I'm doing the same I have a 67 GS That some ass decided to customize my grill and hood. I found a new hoo but from a skylark the problem is that we pulled the scoops off and the scrap man that get the stuff from the body shop. picked the hood up before i could get the holes drilled in the new hood so I have no idea what the measurements are i'm stuck i haven't been able to get that info fromany where I need help If some one could get me those from there car and let me know that would be great Thanks Mike T My EMAIL IS h_o_mike@comcast.net HM number is 904-291-9741
I have and old GS hood I have my old 67 GS hood sitting out beside my barn I could perhaps do some measuring for you? However I also have my new hood on the car (its a '67 Skylark hood)that has not been drilled yet either (not sure I want to?). Anyway the Skylark hood has notches already cut in to the support frame (underneath the hood) for at least a few of the hood scoop pins where they come thru the hood. I always planned to compare these with the pin holes on my old hood and just drill at the center of them and then match up the other pins from there. Let me know if my old hood can/could help you out? Couch
