gonna try and post some pics . may help somebody out , or me if anybody has any suggestions . just cardboard and tape and a little black spray paint for now . not sure what the final material is gonna be - won't really need to be too heavy duty , only holding up the shifter boot etc mainly . will cut apart when close enough and use the 4 templates to form sides of box and then assemble or weld or epoxy or whatever . the pic with the seat is with the seat in full "rear" position ( seat cleaned up real nice , shoulda done that before the pic ) . if you are about 5'2" you might want to consider buckets . ok for me - 6'2" . the square marking in front of box area is approx location of possible floor mods for the shifter rods . seems to sit pretty square and level and was not too hard to do . i know this is not a normal combo but somebody out there may be doing something similar . thanks for the look . del ( hey - hey , it worked !!! )
