400 motor/and pass door

Discussion in 'Parts wanted' started by defan238, Aug 23, 2005.

  1. defan238

    defan238 Well-Known Member

    need a 1968 400 ci motor.pass door eye brow mldg pass side all for '68 gs400
     
    defan238, Aug 23, 2005
    #1
  2. bb455

    bb455 Well-Known Member

    I have a nice running 400 with less than 100,000 miles on her.I may have the trim piece as well.
    where do you live?
    Al
     
    bb455, Aug 23, 2005
    #2
  3. GranSportSedan

    GranSportSedan Guest

    I have a 400 motor all ready to be assembled with new pistons. rebuilt big port heads with new valves.. freshly machined crank. reconditioned rods gasket set, intake manifold, correct oil pan and pickup tube..correct one year only 67 GS exhaust manifolds. nice timing cover etc etc.. sadly it's all from a 67 GS400 any chance you would settle for a 67? the block is a never been stamped factory replacement block. Bob
     
    GranSportSedan, Aug 23, 2005
    #3
  4. GS Spoken Here

    GS Spoken Here Well-Known Member

    Bob if defan 238 is not interested I would like some more information on the motor. I will send you a PM. Thanks Bill Sangster.
     
    GS Spoken Here, Aug 23, 2005
    #4

Share This Page