I'm trying to do as much block work as I can but have been away from engines for a lot of years. I'll still have machine work and cleaning done...
Currently running a stock 455 with eldobrock intake and holley sniper TH400 transmission, 3:42 gear. I was wanting to change the camshaft to...
I am almost to the point of having enough cash to get my 464 block ready to assemble. I still need a cam as well as cam bearings yet. Been looking...
Any common engines that use the same bearings the 350 does? Not a single store in the entire midwest has any cam bearings of any brand in stock....
Good morning. While installing my Crower 50256 cam last night I noticed the front bearing was very tight. I was able to coax the cam into...
So, despite my best efforts, the shop that did my 430 short block put my cam bearings in wrong. They clocked them at 5 and 9 instead of 7 and 3,...
I was installing a set of 455 cam bearings the other day, and managed to get the #5 bearing started pretty crooked. It straightened out...
I am fully aware of the small cam bearings that BBB's are cursed with. I even had a 455 back in the '80s melt the #1 bearing, blocking off the oil...
Cleaning out the garage. All parts are located in Lorain Ohio. 67 GS400 Frame Brackets and Motor Mounts - On Ebay Now 67 GS 400 4 Core Radiator...
on the dual rear grooved cam bearings. does it really matter where the oil holes are on the front cam bearing. say, if you put it in with the oil...
First. Can the front timing cover fit influence oil pressure? Next. Can worn cam bearings infuence oil pressure? Can high valve spring tension...
I get a inquiry once in a while about what to do about a engine that has new cam bearings installed and then the cam wont go into the engine...
I just pulled the front cam bearing on the 455 and noticed that there is a grove in the block. I was planning on ordering TA's grooved cam bearing...
So I had pulled the 455 out of the GSX to replace the crank seal and fix the oil pan that was bent up. I replace all the timing cover bolts with...
I got a 80,000 mile or so long block that I am swapping into my car. The stock cam was somewhat stubborn to remove. But my cam from my motor that...
Got the 455 on the stand still, hoping to dig in to it today to change the bearings. going to pull the old ones out and reinstall them on my...
I am worried about the cam bearing situation, since I'm going to run a TA210S. I don't want to have any problems with this motor, so I'm trying to...