Hi all As I have been unable to obtain a spare tire board, I am going to try making my own. So could someone kindly measure their board and give me the overall diameter and and the diameter of the hole in the centre. Thanks much
Sorry Randy, I hadn't forgotten you, but, it's been about 140*F in the loft where mine is stored so I wasn't lasting very long up there. You'll be happier with one you make than with the one I have. Matt
Reproductions are available if you don't want to make one. Forget the supplier but did buy one of the internet a few years ago.
No worries Matt. I picked up a piece of Masonite from Lowes and I already have the paint needed, so why not give it a shot. Cheers
I know about the repros, but it seems they are back ordered. They are about $30. That combined with the high shipping costs to Canada, will probably top out near $70.oo U.S. My piece of Masonite from Lowes was $7.00, so I will try my own. I am sure what I am doing is not much different from what the repro companies are doing. Cheers
Hi Brian Here are a couple of shots of my tire board. All I need to get now is the board holder. I had one, but damn if I can find it. Total cost out of my pocket this week was $7.00 Cdn., as I had the black paint and the aqua speckles left over from my previous car. Much cheaper than approximately $50-70 U.S.
You could have it shipped to someone in US that lived close and have them just frisbee it over the border and hope it lands in a soft snow bank.
Thanks Matt. IlliniGSX Jim said that the original boards are 5/32" thick. Mine is 1/8" (4/32") thick, which is close enough for me. Cheers
I deliberately leave a few things wrong on my car. That way I don't stress the judges, by having them need to search hard for defects. I really think I am doing them a favour