What kit is everyone using when they do the upgrade to the bigger bar? I read on George's site where he says to use the 9.8117R kit (listed as fitting 71-81 Trans Ams), but I'm also seeing where the 9.8118R kit (listed as fitting 68-72 A-bodies) is also used. I remember trying to figure this out before and if my memory isn't failing me, there is a length difference between the two kits. Is one preferable to the other? Thanks
Check these, best prices I have found. I have bought from them, good all around. They have a 1.25" front bar kit for $119. http://www.muscle-factory.com/shopdisplayproducts.asp?id=253&cat=Sway+Bars+and+bushings Mike
Thanks, but I already have the bar. I'm just trying to figure out the best/correct end link kit to use.
Unless the bar is shaped radically different than a stocker, stock end links should be fine. As long as the links are long enough to fit the bar and bushings with enough thread engagement, you are fine. If necessary, mount the bar and get under there with a tape measure to figure out what link length is necessary to get the bar level and perpendicular to the link.
I'm using the 9.8118 Energy Suspension set and appears to work fine not only for GM A-bodies but also for my '02 F150 p - gotta set in both!
Actually, I'm using them with a Hellwig 1-5/16 front bar, slightly larger in diameter than yours. So you should even have just a little more wiggle room for your install with the 9.8118 My general setup is 1-5/16 front, 1" rear, Bilstien shocks all around, UMI Performance rear control arms.