I dont believe summit has SBB pulleys but I will check. I think I found one via a board member. thanks Gary
Sorry I will explain further I was talking about a dyno shop on rt 8 south. About a mile past turnpike on left.
Hi Guys...well I finally got everything hookep up enough to fire her up and with open header wow is it loud LOL Questions while running it today I would rev her up and the RPM gauge would drop or even go to zero...and the speedometer started to go up...Do you think Im motor ground is the problem? I do now have an accel points eliminator kit and this didn't happen before I pulled the other motor. thanks Gary
Hi Guys, Got the exhaust hooked up and the motor running and thought you guys would like to hear it. Tach is annoying and hope i can figure it out. Still have some issues and things to do but its getting closer! http://youtu.be/3vmk-P2yPIg
Wow Gary, I didn't even know your 350 needed a rebuild. Sounds good. Hope to see ya at Laurel Square some Saturday this Spring. Lon
Thanks guys..she definately has a nice rumble now and i can't wait to see how she accelerates! Hi Lon, well the motor was bone stock and leaking all over so I had to pull it and had a motor sitting around so I thought I might has well do it right once and add a few more ponys:TU:
I think B3R[or something close to that] has a chassis dyno in Brunswick. Buscher Racing has one in Wakeman,and Chambers[CRT,I think,Mustang guys] has one in Norwalk
Just add a little laughing gas and run like this... Stock 350 with nitrous... http://youtu.be/co7fE0BNWt4
HI Sean, no just going to stick with pump gas. Well if anything you know have more spec;s on my motor to add to your book! ---------- Post added at 07:52 AM ---------- Previous post was at 07:51 AM ---------- In Brunswick? Really? never heard of B3R maybe TPS?
Sweet didnt even know about them...was quoted 80.00 for an hour or so shoudl be 3 or four pulls...when Iget her home I will take her there for some numbers.