Where can I find one of these? I know they are a different size (length diameter?) compared to later th400s. Thanks all, -A
Andrew, if your TH400 is a short tail you can use the tail from a newer 400. It's a bolt on & a yoke is available new or would be much easier to find used.
Spline & diam is different on these if I remember right. I pulled one years ago off a '66 225 driveshaft in a local pick-n-pull. Wouldn't slide in later short tail T-400's I have in the garage, not sure where it's at or I'd offer it to you Got Posi :3gears: Roger
Tom and Rodger many thanks fot the information. Ill be going to the Sun Valley Pic-ur-part on monday. -A
I just did one 2 weeks ago on a '65 Riv. as the rear bushings & seals, although available, are getting harder to get, albeit, getting expensive. This was the original trans. for the Riv.
