I have a like new set of TA stage2 TE heads that were never on a motor run in a car.TA ported.I picked these up from a board member for a shortblock I had,I sold the shortblock.The other motor I have need heads with 2.125" intake valve,these are oversize.Comes with matched SP2 intake,dominator base.I would like to trade for TA stage2 SE or TE heads with 2.125" intake.
They are 2.26/1.755", don't have flow #'s,they aren't max ported based on TA description in their book,most likely the level2. Do you have some 2.125 stage2's? gary
yea i have 2.13 valves intake and 1.77 ex fully ported with a SPX also ported from Gessler PM me your # i'll call you tomorrow night we can talk
Gary , I have SE heads need to be finished. I also purchased them here from someone 2.160 in 1.75 ex 11/32 valve bee hive springs, super 7 locks retainers . need finished port work they were started & never finished.. Brand new Spx with bottom cut out & spacers for raising the Intake port.. I paid my Head guy infull to finish ! I Dont think he will.... I can send one to you if you want Nick
hi was wondering if interested in selling them i dont have anything to trade i know your looking for a trade but thought id throw it out there. Would you know anyone wlse with stage 2 heads forsale. anything would be a great help
Gary are you interested in money and my heads . I will send you one . The guy that has them won't respond . I can pick them up if we can work something out . I can tell you that the intake side of the floor will need to be filled and raised . Nick
Nick still holding out for some ready to bolt on,I got the pics of the one you have done,thanks.I added a set of stage3's to the pot in another post hoping to flush something out. gary
hey Nick.is the one head 100% done and were there some flow #s for it?Did you measure the intake valve for me? gary
Gary I have to go to the shop where they are ,, about 45 miles away . I will see if I can go next week & take more picture Or just grab one if you want .. There is only one port that was close to being done . It flowed 342 on the intake @ 28" the Bore plate was 4.500 He measured recalucated And offset to flow . I Dont know how accurate this was... All the Intake ports are TOO long & low in my opinion ... He wants to weld the floor, epoxie to fix the short turn radius .. Then Raise the Roof & change the port Angle entre..... I dont think there is much left to go higher in the head ?? I have an SPX intake un- machined but for a Dominator flange ... I cut the bottom out of the manifold as per His IDEA ??
Nick sounds like theres more effort involved than I was hoping for right now.lets see what else is available before you take anymore time. thanks gary
