These are TA 1.7 ratio roller rockers,includes all mounting hardware, they have been clearanced to clear springs, minimum amount. No problems at all, the only reason I'm selling them is that I have to do a serious upgrade to run the big roller cam in my aluminum race motor. $550 shipped to lower 48 states. Gary G. View attachment 220913 View attachment 220912 View attachment 220914
Interested,what will change regarding pushrod length and valve clearance,I have old KB 1.6 rollers now..thanks...Fish
OK, i ran these on my 455 with stage 2 TE heads, and those heads have the same valve train set up as stock iron heads, so that shouldn't be a problem. Regarding the pushrods, my guess is that you'd have to adjust these rockers as required, then check the roller position on the valve tip at full lift... Decking and head milling will change things. My motor has 9.550 push rods, but I also have a set of 9.400 that i used on a different motor. The lowest I'd go on these rockers is $535 shipped Gary G. ---------- Post added at 04:22 AM ---------- Previous post was at 04:22 AM ---------- OK, i ran these on my 455 with stage 2 TE heads, and those heads have the same valve train set up as stock iron heads, so that shouldn't be a problem. Regarding the pushrods, my guess is that you'd have to adjust these rockers as required, then check the roller position on the valve tip at full lift... Decking and head milling will change things. My motor has 9.550 push rods, but I also have a set of 9.400 that i used on a different motor. The lowest I'd go on these rockers is $535 shipped Gary G.
Thanks Fish. Check your PMs. Rockers are SOLD. Gary G. ---------- Post added at 05:24 AM ---------- Previous post was at 05:24 AM ---------- Thanks Fish. Check your PMs. Rockers are SOLD. Gary G.