Looking for jsut one of the rear bumper rubber spacers for a 1970 GS bumper. Passenger side is the one misisng on my car today - if it makes a difference (I think they are the same). Thanks :TU: , Ross
...uh, not sure, but Ross. . .I "THINK" that lil rubber part you're talking about is the "7 inch block" that sits on the "body channel" at the base of the trunk twixt the body and bumper? If so, I have one for ya. $15 includes box & shipping to lower 48. :TU: Wheelz, Tampa Bay
Ross, The 70's are slightly different from the 71-72's, so you should make sure you get ones for the correct year. Duane
I.. did not know that!!! Hi Duane. . once again, you never fail to impress me with your encyclopedia-brittanica brain of vast Buick knowledge! :Smarty: Could you please explain the diff's in the two years for me/us? I have a boxfull of these things and never knew there was a difference. o No: PIX would be nice too! :TU: ThanX Duane! Wheelz, Tampa Bay
I think you guys are talking about two different things! Ross, I believe, is looking for the bumper filler that is at the top corners of the bumper, and different from 70 -71,2. Wheelz , your talking about the rubber blocks that sit on the rear body seam, and they are the same 70-72
..well, allrighty then! Ok, I think we need to hear from Ross! :TU: Who is correct ... and who is incorrect in their assumption :shock: . . .Ok Ross. . YOUR TURN!!! :beer Wheelz, Tampa Bay
I would think he needs the spacer on the rear body panel under the bumper.B/C there is no way a right bumper filler can work on the left.
I need the top of the bumber spacer. The '70 Chassis Service Manual (Page 140-5) refers to this as a "SNUBBER". Measures 4 1/2" in width. Ross
Guys, What I am talking about are the (qty 2) thick 4"+ long "Extruded" rubber snubbers that sit on the rear body lip against the trunk lid, that the rear bumper sits on. Again, the 70's are slightly different from the 71-72's, so you should make sure you get ones for the correct year. Wheelz, The reason I know about this is because I found out the hard way. Once I got the right set my bumper fit just fine. The differences are slight, but if you match them up end to end you will see they are different. Duane
I'm guessing the part #s should be different? I'll run and check my '70 assembly manual and see what it says.
