I bought their basic conversion plus one iPod input and the USB option. My cost for that was $535. I did not select the Bluetooth option. Here is their price list: Basic conversion for 12 volt operation starting as low as $385.00 for push button radios 1956 and later. Auxialry input kit for CD Satellite radio, iPod, MP3, Tape, etc. - Add $25.00 each. USB 2.0 Port for flashdrives/USB devices, 500 millamps max - Add $125.00 Bluetooth/USB/AUX Connectivity hands free phone and music streaming - Add $225.00 (Bluetooth addon includes USB port and wired analog input) I also bought two 6 x 9 coaxial speakers for the rear deck and the replacement dual speaker to replace the factory mono speaker under the dash. An additional $210. I was also able to negotiate a bit lower price for the entire package and free shipping. SX69 Coaxial 6 x 9" Oval - Our customers kept asking for a high end coaxial 6 x 9 speaker for use with our AM/FM conversion radios. This 6 x 9 utilizes a special titanium /fiber composite woofer cone, rubber surround, and a high energy Mylar film tweeter with built in crossover. Unlike our other speakers, this speaker uses a 20 oz ceramic magnet and is only suitable for rear package tray mounting. It will fit in most of the 1970-1972 GM A body convertibles behind the rear seat in the factory locations. This speaker is of 4 ohm impedance and cannot be used with original factory radios. A speaker of similar quality would cost twice this amount from the national electronics retailers. Price - $109.95 pair including grilles. 4 Ohm Size: 9 1/4"W x 6 3/8"L. 3 1/2" deep. 4 5/8" x 6 5/8" mounting centers. 4" x 10" Special Rectangle Stereo High Output - This speaker uses the same High-Q drivers used in our Dual 6x9 HQ stereo speaker, but mounted on an 11ga laser cut steel plate with a foam rubber gasket to match the mid 60's through early 70's Delco 4 x 10. This speaker will mount back in the car with the original bracket in most cases. It is very light, weighing just over 1 pound. Compare to others using smaller drivers at over 2 1 /2 times the weight. This dual speaker uses drivers with a response curve tailored to open cars providing improved clarity in windy or noisy environments. Available with 4 ohm voice coils suitable for use with our conversion and modern radios or with 8 ohm voice coils for those who wish to install original factory stereo radios in Chevrolet cars but do not wish to cut their kick panels for the original 4 x 6 speakers. Shown without included fabric dust screen for clarity. Price - $99.95 Both 4 ohm and 8 ohm available Size: 10 1/2"L x 4 3/4"W. 2 1/8" deep. No mounting centers - held in by bracket (not included - must use original).
