Need 300 iron heads

Discussion in 'Small Block Tech' started by unclejim, Jul 11, 2004.

  1. unclejim

    unclejim Member

    I need iron heads for a 300. don't need the aluminum ones.

    James
     
  2. $120 for both heads. from a 66. plus shipping
     
  3. unclejim

    unclejim Member

    Please send a photo of the heads and casting number to
    james.taylor@tgme.com

    How much is shipping to California?
     
  4. the heads are on the motor yet. shipping would depend on the zip code. could you supply me with you zip code please
     
  5. unclejim

    unclejim Member

    95032 . How many miles on the engine adn when was the last time a valve job was completed?

    Thanks!
     
  6. it says 66,000 on the speedo and i tend to belive that number. someong took the intake from it already. the valve cover still have the original 300-2 stickers on the covers. i put a socket on the crank and turned it over several times to make sure nothing hung up on it. and it turned fine with no hesitation. i took the plugs out to do this as well. just from my thoughts i would say there has been no valve job done on it yet.
    let me know. i am not going to take the covers off unless you want to buy them for the numbers. thats a good seal to keep moister off the top end
    i will try to get numbers from the outside of the motor where i can find them though
     

Share This Page