Last two parts needed 68-69 GS

I'm down to the last two or so pieces that I need :


I need a passenger side rear wheel moulding, just driver quality is fine.
It must be the full moulding.

I also need one early center cap, the one with the fluted sides.
Driver quality on that too, missing or cracked lens ok, must have
retaining ring though.

Any used 69 GS interior door panel emblems.

That would pretty much make my car complete.

I can pick up at GS Nats.....if wife lets me go ou:

 

There are repros available if you aren't able to track down a used cap.

 

Thanks David, I just found them in postons at a pretty good price.
This is my "Budget Buick" I have less than $1800 wrapped up in this,
including car, which I traded an old dirtbike for!

 

What is Poston's price? I highly recommend using Mitch Romanowski's reproductions, which were around $38 a couple years ago. I have them on my 68, and they are absolutely beautiful reproductions. They have a locking mounting design, so someone can't just pull it off your wheel. He goes by mitchr on the board. I believe some of the bigger vendors sell his stuff, not sure about Postons.