I can't seem to find the torque specs for my 72 Skylark convertible front end. Will be re-installing the control arms, springs shocks etc this weekend and hoping someone might have all the specs their willing to share . Not sure what you call the bolts/arms that attach the upper control arms to the frame and on the end of that shaft but any tips (besides correct shim replacement) to get that aligned? Am I just trying to make sure that shaft is centered from left to right? (I didn't measure it before I removed it ..... Thanks again all!
yeah thanks... I found that out after I did the rear bushings and before I did the front... I have the front all installed and "snug". once the motor goes in I will torque them. there are "0" miles on the rear, so I might loosen them up and re-torque them when the motor is back in as well.