http://www.ebay.com/itm/291380564525?item=291380564525&viewitem=&vxp=mtr#ht_285wt_908 Get em before they are gone. My supplier keeps raising prices on me......
Sorry, no only Dominator. I tried to get manufacturer to make in 5 1/8 (130mm) for regular Holley and Qjet but tooling cost was too high and minimum order of 2,000!
Yup, that's where it started Alan..... I remember Redline Ron's story about going to a kitchen supply store waving splatter screens around and getting funny looks after he saw mine attached to underside of hood on BQUICK. My original came directly from the kitchen complete with sauage grease on it.
I've used this device and I did pick up a little in the quarter. Thanks to Tuna.. Plus I made pasta for lunch at the track.. Bruce, I maybe down for 2 of them... Due to my new set up..:laugh:
I bought one of these. The quality is very good. I did have to open up the screen area around the vent tubes on my 1050 C.F.M. Holley Dominator because the vent tubes stuck up through the screen. Mike D.
It would be better to shorten the vent tube, Mike. Having the vent tube under the screen gives it a steadier pressure. Also would prevent debris getting in.
No Gary, no PAYPAL. Are you sure you sent to right email? Also, your PM had no content. The one before bounced due to my mailbox full. Hugger's was sent out.
Hey Bruce, this is bonehead here, left off the S in your email, duh. Corrected that and sent paypal thanks gary
No problem Gary. Out of stock at the moment, though. I should have some soon. They are stuck on a boat in Long Beach, CA.