Just question guys what is the proper cleaning technique and materials that I should use to clean up my 350 block.. the pistons, crank, timing chain, basepan are still attached but I have the dome, carb, distributor, heads all off..... Thanks for any help you can give me
suggest that u cover & tape the cylinders & centrehead areas to keep them dry . use a good degreaser or steam or soap & water and rinse clean . use lacquer thinner or toluene to finish the job .
Think Im going to pull everything and get the block cleaned up maybe bored so that I can pull some more horses out of it..... Any ideas on this or problems that Im going to run into.... I have been looking around for a bigger engine but Ill play with this one until I get something....
