carter problem

Discussion in 'The Mixing shop.' started by BuickLeSabre1960, Aug 18, 2004.

  1. BuickLeSabre1960

    BuickLeSabre1960 Hot Dogs Anyone?

    Ok, My brother just switched to a '66 carter 4-barrel on his '66 Catalina 389 and it has a flat spot under light acceleration. Someone had said it might be the accelerator pump but I don't think so because you can hold it at the point where it stutters and it will keep stuttering. I tried putting new jets (edelbrock #1426 .095 orifice) in it and forgot to put the rods in and it ran good but when I put the rods (edelbrock #1455 7042) in it was back to stuttering. The step-up springs are edelbrock silver 8-in. Hg.
     
  2. BuickLeSabre1960

    BuickLeSabre1960 Hot Dogs Anyone?

    oh, and the idle mixture screws don't react
     
    Last edited: Aug 20, 2004
  3. 462CID

    462CID Buick newbie since '89

    First I would get the carb to run on the idle circuit, sounds like you're idling on the primaries

    Which Carter carb is it?
     
  4. BuickLeSabre1960

    BuickLeSabre1960 Hot Dogs Anyone?

    How would I go about that? It's a 625cfm off of a '66 389 GTO
     

Share This Page