was gonna list this on CL and / or e-bay in a few days anyway - got thinkin it may make someone a nice nailhead ( or whatever ) carb . $150.00 plus shipping ( $125 to cover my fanny - $25 for V8B - I sell sometimes - i'm due - couple other things later ) checked it over and took it apart , soaked and flushed it , reassembled using edelbrock 750 spec parts , polished er up a little as I went along . added black allen head screws - look kinda nice I think . ( oem torx screws and basic 3/8" inline filter included ) . used edelbrock #1472 gasket kit and #1467 pump , floats passed the water test , needle and seats looked ok . primary jets - 413 ( .113 ) , secondary jets - 407 ( .107 ) , metering rods - .071 x .047 . floats set at 7/16" , float drop set at 15/16" . pump rod set at "center" and idle screws set at 1.5 full turns out as a start up point . any questions let me know . trades ?? depends .
bump @@@ edit @@@ - maybe i'll send it to CL or ebay thur or tues - if the moneys ok the donation will still happen .
Brandon : did not notice ya popped in . yep , same one . it wasn't too bad once I got it apart and looked through it . had to work on the choke cable bracket and a couple little things and then it was just some extra time cleanin n polishing etc . anyway - sold @ e-bay - donation Monday probably when caught up . gotta box 'er up . @@@ edit @@@ carb shipped , donation done !