cam for 72 gs 350

Hello my buddy has a 72 gs stock 350 100k going to rebuild MOTOR .030 over whats a good cam to run as a upgrade to a 72 smog cam nothing big thanks

 

TA-112 = 210- 215 duration. lift =455-468 on a 110 lsa. or any other brand with similar specs.

 

x2 for TA 112:

https://www.taperformance.com/proddetail.asp?prod=TA_112-350

Devon

 

Thanks guys hope TA has them in stock

 

Crossing fingers!

Devon

 

Be sure to install new valve springs.

 

What pistons you going to use?
Before I ordered a cam, I’d check to find out where you’re going to end up compression wise.
.030 pistons if they’re generic “rebuilder” pistons you MAY end up with LESS than 8 to 1 comp ratio as a lot sit pretty far “in the hole”

 

I have a Comp 268H in a dead stock 71 350 and it runs very well. Actually better than I expected it to. Used it because I had it, so there are better options if you are buying one for the application, but this would be a good option if others are not available.
Thanks
Brent

 

I rebuilt a 71 GS 350 engine over the last few years (it took that long to get machine work) and I decked the block, shaved the heads to get it to a true 9:1 compression ratio. The bore was standard at 91K miles and didn't need boring. I used a TA 212 cam and it is pretty sedate and runs on cheap 87 gas.

 

Thanks guys, great advice I told him with that cam 9 to 1 compression would run sweet

 

This is my wife driving my 71 4-speed shortly after we broke in the cam and got the exhaust buttoned up if that helps.

 

Thank You Greg, sounds and looks Sweet!!!!