sorry to double post this but i figured i'd start out fresh on this subject as the other thread was actually a v6 thread.. i'm still on the buick 350 to toyota swap still, getting more and more serious. now i'm not going to list every lil part needed for the swap just the main ones buick 350 from my 72 skylark along with the "bop" th350 put in a 4x4 output shaft to hold the engine i'll use the v6 motor mounts from Advance Adapters i'll get the tranny to 21 spline xfercase adapter from AA 86-88 toyota manual transfer case 160 tooth flywheel dual electric fans Now onto my concerns radiator, i imagine i'll have to get a custom sized rad oncording to the guy at advance adapters i might run into oilpan and exhuast clearnece issues....they never did this swap themselfs...just because every1 is into chevys.. now to counter the last 2 possible problems would a simple lift counter those? i'm sure i could always get a custom oilpan and exhaust too but my thoughts on this is....if they did it with a chevy 350 i'm sure if couldnt be anyharder to do it with a buick 350 or any other gm350 right? lastly i would have to modify an oilpan from a 350 equipped vehicle right? and or would a buick 321 oil pan work? thanks again guys