I have replaced the Benchseat in my 65 Cat, I have a pair of Buckets that I think came from a another Cat or maybe a Riv??? My Small problem is that one of the legs does not match up with the floor, I tried to use the same holes that the bench seat used and I have have to drill and tap the floor and the cross support under the car that runs across to get the max holding strength. On the Passeneger side the floor drops off and the leg close to the tranny tunnel is off the floor by an inch or less. What have people done in the past? Do you just move the seat back a little? I had no problem with the Driver's side so moving it back would make the seats uneven looking????? Don
