"BE" stamped original master cylinder.....pulled from a 71 or 72 Olds Cutlass. >Dismantled (other than the brake line brass seats....easily removed as well), cleaned and beadblasted. Followed up with a couple light coats of cast grey paint to prevent flash rusting. Should be stripped again and painted during a rebuild/sleeving process. >Have a choice of two caps (w/used rubber cap seal) - 1st choice is a replated later GM cap that doesn't have the "correct" lettering compared to original caps. 2nd choice is a repro lid from The Parts Place. >Includes the original bale for the lid - nice and smooth...not pitted and crusty like lots of original bales are. Bale should probably be plated w/your choice of finishes. >It's a disc brake master so it has the 1-1/8" bore. The bore will need sleeving as it has pitting, etc in it. >Original forward piston retaining bolt included (not in the pics) and I have the old bleeders as well but they're crusty and should be replaced. >"BE" stamping is clearly visible....not perfect at the bottom of the "E" but plenty visible. I may also list this on other Abody sites so subject to prior sale. $90 + shipping to the lower 48. Payment by check, MO or PayPal FRIENDS AND FAMILY. Send me your COMPLETE shipping address in a PM and I can determine the ship cost.