I hate to say it, but I'm putting all my BBB goodies up for sale. Here's the short list of what I have (I'm sure there's more). All prices are plus shipping. T&D Roller Rockers (never ground or modified) 625.00 SOLD T/A Roller cam with lifters (no more than 800 miles on them) 500.00 MSD Billet Pro Distributor 800 miles will include a TA brass cam gear 250.00 SOLD Taylor 10.0 (I believe) Silicon wires with looms 70.00 SOLD TA Alum Valve Covers (Black but could use some paint or powder coating) 125.00 SOLD Good timing cover with TA pressure plate and proper spring setup (ready to run) 200.00 SOLD Switch Pitch400 with 1200/3000 stall deep alum pan included 800.00 Steff's Oil Pan with Main Halo Girdle and pickup 300.00. SOLD 1970 Iron head with Big Stainless Valves, Hardened seats, light port work, and new springs and seals. 600.00 462 Short block with 800 miles: 1500.00 Block has been filled with hardblock to lower water pump port. Build by C&T Machine Forged dished pistons TotalSeal file fit rings Race 3/4 grove bearings (Rods and Mains) TA Double grooved Teflon coated cam bearings This is all I can think of at the moment. Priced to sale, let me know if you have any questions. --Rich
I was running a Thick Cometic gasket that I sold as part of the Procharger setup. With a standard TA type Orange Crush gasket you'll be around 9.5 to 1. The block was decked to be cleaned up for a fresh build, but not "Zero'd". --Rich
I'm in line for the roller rockers (are they the 5/8 shaft on those ) and alsothe MSD Distributor. Bill
6Qt pan I believe, BG would depend on when it shipped out. It could ship as early as tomorrow. I'd plan on around 75.00 for shipping. It's large and the girdle will make it heavy.
Come to thom of it, it's probably 7qt. Seems like I put 6.25 in it but the main cap girdle eats up some oil capacity.
