Been a bit since I updated anything. I got a lot done this winter. Frame sand blasted and painted with VHT Chassis epoxy paint Rear lower control arms boxed in All rear control arms and front a-arms blasted and powder coated New 5335 rear springs Front original springs blasted and powder coated Front spindles and disc brake hardware blasted and powder coated Original front calipers rebuilt and painted New front and rear brakes, rotors, drums including all new rear brake hardware and parking brake cables New AC Delco front and rear Shocks New Moog upper and lower Ball joints New inner/outer tie rods, center sleeves and centerlink New idler Arm New rear sway bar New front sway bar and bushings All new Inline Tube brake lines and clips New Inline Tube fuel and return lines New GM34B fuel tank New Fuel cap New Sending unit and new rubber lines New Fuel sending unit wire to main harness Fuel tank straps, blasted and powder coated with new strap hardware New front bearings I rebuilt power steering box and painted New Body mount bushings New Parking brake cable through body Crossmember and crossmember mounts blasted and powder coated Body dropped back on frame Probably forgetting a few things but if it was under the car it was most likely rebuilt or replaced. M20 4 speed at the shop getting a once over. Engine at the shop, dropped off all parts, should have back in 2 months.
Also had these Grills powder coated and used Amazon chrome pens to outline. I know not 100% correct but neither is rest of the car.
