Hi, I am actually looking at putting something together instead of taking it apart :Brow: This question has been asked before so just to confirm. Rear sway bar mounting holes on a lower control arm for a 64 Skylark. 5.9" from the rear of the arm as per picture, 6" center to the next hole. In the center of the arm top to bottom. There's only two thru holes per arm, Right? What diameter are the holes? I'm going to cut down the center section of a control arm bushing to weld in before boxing them. Thanks Bruce
im not pulling them out again! :rant: 7/16 bolts if i remember. actually 20 min ago i was under the 69 looking at my 3 sided arms uzzled: i dont think they will last if the car goes like i think it will :3gears:
