63 Riviera rear end

Discussion in 'Got gears?' started by Chris Chandler, Apr 2, 2018.

  1. Chris Chandler

    Chris Chandler Active Member

    So I had some questions on my 63 Riv rear axle and housing. What is it? I'm used to GM 10 bolt and 12 bolts. Never seen one like this. I was talking on another thread that I want to put a 455 in this car. But I need an axle that can handle the massive torque. Are there parts I can buy for it? Or should I swap it out for something else?
     
  2. telriv

    telriv Well-Known Member

    It's a Buick 9 3/8ths. NO AFTERMARKET SUPPORT. ONLY bearings, seals, etc. IT CAN HANDLE THE TORQUE.
     
  3. flynbuick

    flynbuick Super Moderator Staff Member

    There was someone on here recently that had some used 9 3/8" rear ends that were from the same era.
     
  4. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

  5. Chris Chandler

    Chris Chandler Active Member

    I need to find that guy.
     
  6. LARRY70GS

    LARRY70GS a.k.a. "THE WIZARD"

    Post on his thread. then click on his avatar, then "start a conversation" That will send him a private message.
     
  7. Chris Chandler

    Chris Chandler Active Member

    Thanks for that. I will get in touch with him right away.
     
  8. monzaz

    monzaz Jim

    We built a dana 60 for the older riv car once...It was a crazy undertaking... We even let them use the ORIGINAL drum breaks too. Which I was trying to take them out of... they wanted 4.10 ratio and a burn out machine. :)
    I think this was a 67 68 rear... had to use the original rear for parts like brackets and housing end s etc.
     

    Attached Files:

    cjeboyle likes this.

Share This Page