Went to TA's page and they don't show headers to fit in a 66 Skylark with a 350 Buick engine installed....anyone have any ideas on this? Little help here, gonna be pissed if I build a 350 Buick for my car and I can't get headers for it.
same problem , except its a 65 . poston does not list them either and both places told me that the 68 and newer 350 headers won't fit , clearance issues in the driver side frame rail most likely . could always go with some cu$tom built ones ! i was on here before about this and was wondering about using some ta exh flange plates and then mating them to some small block chev/mopar block hugger or similar headers - exit angle would have to be played with . but the exhaust port layout is very very close . del
OL this is just gay! Has anyone tryed to ones from a 68 up on a 65-67? :rant: Now I was thinking that very same thing, Buick flange grafted to a set on small block headers for a 66 Chevelle...hum....
