Not sure where to put this as I don't need parts for a Buick. Looking for a RH rear fender for a '34 or '35 Chevrolet Standard 3 window coupe. Any condition considered. No repro's available. We're currently getting ready to make one from 3 different donors. Car is fresh out of Alberta & was used on a farm for a few years. Original paint, original pin-stripes. Shell is about as mint as anyone will find. Driver's door has a 12 gauge pot-shot thru it, we have a replacement. The RH rear fender was off the car & stored upside down in the weather. Complete top half of the fender rusted out. Cheers,
The H.A.M.B. is the place to go. Lots of those kind of car peeps over there.www.jalopyjournal.com/forum/
If you have some donor fenders to work from just cut out the rotted section, use it as a stencil on a good donor and cut it out, weld back into the original fender. You can do the same for the shotgun hole. Cut out the hole on each side and weld in a patch. Then you can use the replacement door and remaining fenders for swapping.