All parts are very good to excellent condition driver side fender both front inner wheel house trunk lid driver side rear bumper filler core support 455 intake ac blower box
No, the factory frame mounts are very hard to find. I used the more common 70-72 A-Body mounts. They will work just fine. They are more work though, because you have to drill new mounting holes. The way I did it was to install the motor mounts to the engine with the frame mounts bolted up. The tranny and drive shaft were still installed in the original location. Then I dropped the engine into place. Bolted up to tranny with all accessories installed for checking clearances. Setting on the cross member, adjust position for best fit. After that I took spray primer and painted around the frame mounts. Make sure all edges of mounts are definable. Remove engine and you will have a good paint template for drilling your new holes. Drill holes, install frame mounts, then the engine should drop into place. It's a lot of extra work to install the engine twice, but this worked well for me. ---------- Post added at 10:23 AM ---------- Previous post was at 10:17 AM ---------- I only have one side. Not sure which. I will go look to know which side I have and get back to you if your still interested. Thans Brian