1970 GS 455 driveshaft

I'm in Indiana. Looking for a single 455/400 driveshaft. Can pickup if close.

Spence

 

I may have one down here in sunny South Central Florida. I have shipped them all over the country. Please email me to discuss: drolds1@bellsouth.net. Thanks, Bob.

 

I believe that should be 55” center to center.

 

I'm sure I have one in Wisconsin

 

Since Freakzilla needs one for an auto car would it be a conflict to ask for a 1970 455 4-speed car (Muncie & 8.2) I need?
If they are the same please disregard, currently has a Muncie w/ 350 driveshaft going to an 1972 8.5 rear that I am replacing with the 70 8.2 3:64 rear.
I’ll delete if needed but appreciate if that’s okay .

 

I'll check on yours as well. Thanks, Bob.

 

The 4-speed driveshaft is 1” longer than the automatic. Why? The TH400 is 1” longer than the 70-older Muncie 4-speed transmission. The 71-74 Muncie with the large output is the same length as the TH400. I can double-check my original 70 GS 4-speed shaft. I sent my last good auto shaft to Nelson. He could double-check the length on that one.

 

I can check.

 

Ask John Stevens....he is in central Indiana

Peace WildBill

 

Ok Picture attached. Center to center.



.

 

I measured mine yesterday, it's 62" cap to cap.

 

Any one recommend a good after market supplier?