1966 skylark front windshield inside plastic trim

Discussion in 'Parts wanted' started by john m, Feb 24, 2016.

  1. john m

    john m Well-Known Member

    Your piece has same lines as ebay picture ill call them tomorrow and see if its for rust repair or interior pillar cover ,because mine has different lines than yours .Like round over by windshield edge.
     
  2. john m

    john m Well-Known Member

    Bob thanks also can you measure rear seat length top and bottom from left to right may have found set close to home want longest length measurment on top and bottom please thanks John
     
  3. Jerseysky66

    Jerseysky66 Silver Level contributor

    John, Top of the top seat across is around 50 1/2" and the middle section of Top I measure around 51"

    Bottom Section looks to be around 52" across. Bottom section fits very tight between the arm rests.

    Post us a larger picture of your windshield pillar section.

    Bob
     
  4. john m

    john m Well-Known Member

    Thanks going in garage 1/2 hour
     
  5. john m

    john m Well-Known Member

    IMG_0504.jpg IMG_0506.jpg

    Think wiley is right.
     
  6. john m

    john m Well-Known Member

  7. Jerseysky66

    Jerseysky66 Silver Level contributor

    It does look right - Just need the windlace.

    Good Luck with the seat.
     
  8. wkillgs

    wkillgs Gold Level Contributor

    Usually!:grin:

    I do my best to post correct information. I'll look it up in my manuals or head out to the garage and take a look before I post an answer.
    Been playing with my 66's since I was 15.... that was almost 40 years ago!
     

Share This Page